HP Z8 Fury G5 - Feet; Front Bezel

Feet
To remove the feet, use these procedures.
Before removing the feet, follow this step:
■
Prepare the computer for disassembly (see Preparation for disassembly on page 26).
Remove the feet:
1. Use a case utility tool (1) to detach the foot screw covers (2).
2. Remove the Torx10 screw (3) that secures the foot to the computer.
3. Remove the foot (4) from the computer.
To install the feet, reverse the removal procedure.
Front bezel
To remove the front bezel, use these procedures.
Before removing the front bezel, follow this step:
■
Prepare the computer for disassembly (see Preparation for disassembly on page 26).
Remove the front bezel:
1. Position the computer on its right side with the bottom toward you.
2. Release the two tabs (1) on the bottom of the front bezel from the computer.
3. Swing the bottom edge of the front bezel (2) away from the computer.
Feet
27