HP Z8 Fury G5 - Access Panel; Hard Drive

Access panel
To remove the access panel, use these procedures.
Before removing the access panel, follow this step:
■
Prepare the computer for disassembly (see Preparation for disassembly on page 26).
Remove the access panel:
1. Position the computer with the left side toward you.
2. Pull the access panel release latch (1).
3. Use the access panel release latch to swing the top edge of the access panel (2) away from
the computer.
4. Remove the access panel (3) by lifting it straight up.
To install the access panel, reverse the removal procedure.
Hard drive
To remove the hard drive, use these procedures.
IMPORTANT: To prevent loss of work and damage to the computer or drive:
● If you are inserting or removing a drive, shut down the operating system properly, turn off the
computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby
mode.
● Before handling a drive, be sure that you are discharged of static electricity. While handling a drive,
avoid touching the connector.
● Handle a drive carefully; do not drop it.
● Do not use excessive force when inserting a drive.
Access panel
29