●
For cabinet installation, ensure adequate cabinet ventilation and ensure that the ambient temperature
within the cabinet does not exceed specified limits.
●
Never restrict the incoming or outgoing airflow of the workstation by blocking any vents or air intakes,
as shown in the following figure.
Setup procedures
WARNING! To reduce the risk of electric shock or damage to your equipment, observe these practices:
• Plug the power cord into an AC outlet that is easily accessible.
• Disconnect power from the workstation by unplugging the power cord from the AC outlet (not by
unplugging the power cord from the workstation).
• Plug the cord into a grounded (earthed) three-pin outlet. Do not disable the power cord grounding pin (for
example, by attaching a two-pin adapter). The grounding pin is an important safety feature.
NOTE: An HP Z840 Workstation with a 1125 W power supply might require more power than the typical
office environment can supply. For details, see the Site Preparation Guide for the workstation at
http://www.hp.com/support/workstation_manuals.
To set up the workstation:
1. Connect the mouse, keyboard, and power cord to the workstation.
2. Connect the monitor to the workstation.
3. Connect other peripheral components (such as a printer) according to the instructions included with the
device.
4. Connect a network cable to the workstation and to a network router or LAN device.
5. Plug the workstation power cord and monitor power cord into an AC outlet.
Setup procedures 13
To Next Page
Loading...
Need help?
General
