1.5 The Emergency Stop Button
The CodeMax
®
has an emergency stop button installed.
Pushing the emergency stop button at any time will immediately freeze the operation in
which the machine is engaged. For example, if you started the cutting process and realized
you had the wrong cutter or key blank, pushing the emergency stop button would instantly
turn off the cutter motor and stop the pivot arm from traveling.
To reset the CodeMax
®
, after the
machine freezes, push the emergency
stop button until it pops out, and
the machine will return to its Home
Position. Make the necessary
adjustments (e.g. put the shoulder
gauge down, or install the correct
cutter or key blank), and start the key
cutting process again.
*Note: When the emergency stop button is pushed, the CodeMax
®
will clear the bittings entered,
if the bittings were entered directly on the CodeMax
®
keypad.
If you have any questions, please call the HPC Service Dept. 1-800-323-3295.
10
CodeMax
®
CodeMax
®
To Next Page
Loading...
