HPC CodeMax - Micrometer Key Cutting

4.3 Micrometer Key Cutting
From the main screen press DSD#. The display shows:
Press “0” to signify that you wish to use the micrometer function of the CodeMax
®
. Press
ENTER and the display changes to:
The display then changes to:
Press A, B, or C to signify which jaw will be used. For our example, press A. The display
changes to:
Press A or B to indicate the use of inches or millimeters for space and depth measurements.
For this example, press A for inches. The CodeMax
®
advances to the main micrometer
screen and the display shows:
39
Micrometer Key
Cutting Function
Enter DSD Number
[ ]
Choose: A for In
B for mm
Space 0.000 In
Depth 0.000 In
Enter Jaw Type
[ ]
CodeMax
®
CodeMax
®