2.3 Resharpening Cutter Wheels
One of the most important features of the CodeMax
®
is its capability to maintain correct
depth and spacing with virtually no setup time involved, including the changing of the
cutter wheels. This capability is dependent upon the use of cutters whose outside diameters
are carefully calibrated. We recommend using only HPC cutter wheels.
Eventually, cutters become worn and should be replaced. We do not recommend sharpening
cutters.The diameter of a resharpened
In order to maintain matched cutter diameters, all cutters for the CodeMax
®
must be
resharpened at the same time to account for material lost during this process.
cutter is smaller and will therefore make cuts shallower
See Depth Adjustment Section (5.2) for further information.
14
CodeMax
®
if no depth adjustment is made.
To Next Page
Loading...
