HPC CodeMax - Additional Notes

4.1.4 Additional Notes
1) The CodeMax
®
always cuts shoulder-gauged keys from bow to tip, and tip-gauge keys
entered into the CodeMax
®
in bow to
2)
If the original manufacturer (such as Kwikset) widens some or all of the cuts, the
CodeMax
®
will automatically do the same.
3) When cutting double-sided keys where there is a shoulder on only one side of the key,
or where the shoulders are not symmetrical (such as some VW keys), always cut the
shoulder gauged side of the key first, then press ENTER to cut the plain side.
4)
Because most double-sided keys are
gauged by placing an uncut blade against the
procedure is to cut the first side on the
®
and then cut both sides of another
blank in a duplicator, using the code-cut
5) At all screens you may press CLEAR to return to the previous screen.
36
CodeMax
®
from tip to bow. However, all bittings must be
tip order.
back of the jaw, the recommended cutting
CodeMax
key as the original.