To Next PageTo Next Page
Need help?Do you have a question about the HPE 3PAR StoreServ 9000 and is the answer not in the manual?
General| Model | HPE 3PAR StoreServ 9000 |
|---|---|
| Architecture | Scale-out, multi-controller |
| Operating System | HPE 3PAR OS |
| System Availability | 99.9999% |
| Drive Types | SSD, SAS |
| Data Protection | snapshots, remote replication |
| RAID Levels | RAID 1, RAID 5, RAID 6 |
| Protocols Supported | FC, iSCSI, FCoE |
| Host Connectivity | 16 Gb/s Fibre Channel, 10 GbE iSCSI |
| Management Software | HPE 3PAR Management Console |
| Data Services | Thin provisioning, snapshots, replication |
| Data Reduction | Deduplication and compression |
| Maximum Effective Capacity | Up to 20 PB with data reduction |
| Scalability | Scale from 2 to 8 nodes |
Recommended technical skills and experience for CSI installers.
Detailed procedure for unpacking the HPE rack with the integrated storage system.
Steps to remove banding and top cover from the HPE rack shipping container.
Steps to remove packing material, foam, and ESD covers from the rack.
Procedure to remove L-brackets securing the rack to the pallet.
Instructions for safely rolling the rack off the pallet to the floor.
Procedure to install leveling pads and level the HPE rack.
Critical guidelines for installing, allocating, and balancing storage drives.
Guidelines for ensuring power redundancy through proper cabling.
Guidelines for connecting hosts to the controller nodes.
Safety precautions to follow before powering on the storage system.
Procedure to verify AC power cable connections are correct.
Step-by-step instructions for powering on the storage system.
Detailed steps to check power redundancy by cycling PDUs.
Requirements for network and firewall access for service processor connectivity.
Details on configuring firewalls and proxy servers for service processor connectivity.
Steps to assign an IP address to the physical SP using the Guided Setup.
Procedure to deploy the virtual service processor on a VMware ESXi host.
Steps to locate or assign an IP address to the virtual SP in VMware ESXi.
Procedure to deploy the virtual service processor on a Hyper-V host.
Steps to assign an IP address to the virtual SP in Hyper-V.
Conditions and requirements that must be met before using HPE 3PAR Guided Setup.
Procedure to configure the service processor using the HPE 3PAR Guided Setup utility.
Procedure to configure the storage system using the HPE 3PAR Guided Setup utility.
Steps to access HPE InfoSight and register the storage system.
Procedure to register the storage system with HPE InfoSight using the SSMC.
Information on enabling and managing data encryption for storage drives.
Explanation of alerts triggered by events and processed by the service processor.
Procedure to check the system health using the Service Console interface.
