The resulting display will appear similar to the following:
switch(config)# show ip rip interface
RIP interface information
IP Address Status Send mode Recv mode Metric Auth
--------------- ----------- ---------------- ---------- ----------- ----
100.1.0.1 enabled V2-only V2-only 1 none
100.2.0.1 enabled V2-only V2-only 1 none
100.3.0.1 enabled V2-only V2-only 1 none
100.4.0.1 enabled V2-only V2-only 1 none
You can also display the information for a single RIP VLAN interface, by specifying the VLAN ID for the interface,
or by specifying the IP address for the interface.
RIP interface output by VLAN
To show the RIP interface information for VLAN 1000, use the show ip rip interface vlan vid
command.
switch# show ip rip interface vlan 4
RIP configuration and statistics for VLAN 4
RIP interface information for 100.4.0.1
IP Address : 100.4.0.1
Status : enabled
Send Mode : V2-only
Recv mode : V2-only
Metric : 1
Auth : none
Bad packets received : 0
Bad routes received : 0
Sent updates : 0
For definitions of the fields in, see
Viewing general RIP information on page 174.
The RIP interface information also includes the following fields:
Bad packets received
Number of packets that were received on this interface and were not processed for any reason.
Bad routes received
Number of route entries that were received on this interface and were not processed for any reason.
Sent updates
Number of RIP routing updates that have been sent on this interface.
Example:
Example of show IP rip interface output by IP address
To show the RIP interface information for the interface with IP address 100.2.0.1, enter the show ip rip
interface command:
switch# show ip rip interface 100.2.0.1
176 Aruba 3810 / 5400R Multicast and Routing Guide for ArubaOS-
Switch 16.08
To Next Page
Loading...
