HPE Aruba 3810 - Operating notes

IP RIP interface under VLAN context
switch(vlan-1)# show ip rip interface
RIP interface information
IP Address Status Send mode Recv mode Metric Auth
---------- ------- --------- --------- ----- -----
30.0.0.1 Enabled V2-only V2-only 1 MD5
Syntax
Show key-chain key-name
Show association with RIPv2 interface if any.
Show key-chain
DUT1(vlan-30)# show key-chain abc
Chain - test2
Key | Accept Start GMT Accept Stop GMT Send Start GMT Send Stop GMT
--- + ---------------- --------------- -------------- -----------------
1 | Bootup Infinite Bootup Infinite
OSPF Interface References
Interface
---------------
OSPF Virtual Link References
Area/Virtual Link
------------------------------
RIP Interface References
Interface
----------
30.0.0.1
Operating notes
• If the authentication type MD5 is configured without a md5-auth-key-chain, the authentication will fail.
• If the md5-auth-key-chain is configured but authentication type not set to MD5, the authentication will fail.
• If the authentication type MD5 is configured and the md5-auth-key-chain is already configured, the MD5
authentication will begin working.
• If the md5-auth-key-chain is configured but the authentication type set to MD5, the MD5 authentication will
begin working.
• When the MD5 authentication is working and you remove the md5-auth-key-chain, the MD5 authentication
will fail.
• When the MD5 authentication is working and you change authentication type to other than MD5, the MD5
authentication will fail.
• When the MD5 authentication is working and you remove the used key-chain from global configuration, the
request to remove the used keychain will fail.
184 Aruba 3810 / 5400R Multicast and Routing Guide for ArubaOS-
Switch 16.08