HPE Aruba 3810 - Modifying existing commands; [no] sys-debug <FILTER-TYPE> | <FILTER-OPTIONS>; debug ipv6 fib blackhole; [no] sys-debug <DESTINATION> [logging | buffer]

Stack-switch-name(config)# show debug
Debug Logging
Source IP Selection: Outgoing Interface
Origin identifier: Outgoing Interface IP
Destination:
Session
Memory buffer
Enabled debug types:
ip fib blackhole which is enabling debug and adding sys0debug config in running-config for persistance across reload.
ipv6 fib blackhole
tty=none Stack-switch-name(config)# show run
Running configuration:
; hpStack Configuration Editor; Created on release #KA.16.02.0000x
; Ver #0d:00.92.34.5f.3c.6b.fb.ff.fd.ff.ff.3f.ef:8a
stacking
member 1 type "J9586A" mac-address 5065f3-b4e200
member 2 type "J9575A" mac-address 5cb901-26c0c0
member 3 type "J9575A" mac-address 5cb901-26c880
exit
hostname "Stack-switch-name"
sys-debug ip fib blackhole
sys-debug ipv6 fib blackhole
sys-debug destination buffer
no rest-interface
Modifying existing commands
[no] sys-debug <FILTER-TYPE> | <FILTER-OPTIONS>
Syntax
sys-debug <FILTER-TYPE> | <FILTER-OPTIONS>
[no] sys-debug <FILTER-TYPE> | <FILTER-OPTIONS>
Description
Used to configure the type of messages displayed in the log.
Options
Filter-type
Either IP or IPv6.
Filter-options
Use the filter term “blackhole”.
debug ipv6 fib blackhole
Within the config context:
Syntax
debug ipv6 fib blackhole
Description
Enable blackhole logging
Usage
[no] debug ipv6 fib blackhole
[no] sys-debug <DESTINATION> [logging | buffer]
Syntax
sys-debug <DESTINATION> [logging | buffer]
[no] sys-debug <DESTINATION> [logging | buffer]
166 Aruba 3810 / 5400R Multicast and Routing Guide for ArubaOS-
Switch 16.08