HPE Aruba 3810 - Using the debug command with the VRRP option

switch(config)# show vrrp
VRRP Global Statistics Information
VRRP Enabled : Yes
Invalid VRID Pkts Rx : 0
Checksum Error Pkts Rx : 0
Bad Version Pkts Rx : 0
Virtual Routers Respond to Ping Requests : No
VRRP Virtual Router Statistics Information
Vlan ID : 22
Virtual Router ID : 1
Protocol Version : 2
State : Initialize
Up Time : 64 mins
Virtual MAC Address : 00005e-000101
Master's IP Address : 10.10.20.2
Associated IP Addr Count : 1 Near Failovers : 0
Advertise Pkts Rx : 0 Become Master : 0
Zero Priority Rx : 0 Zero Priority Tx : 0
Bad Length Pkts : 0 Bad Type Pkts : 0
Mismatched Interval Pkts : 0 Mismatched Addr List Pkts : 0
Mismatched IP TTL Pkts : 0 Mismatched Auth Type Pkts : 0
The show vrrp ipv6 statistics command
switch# show vrrp ipv6 statistics
VRRP Global Statistics Information
VRRP Enabled : Yes
Invalid VRID Pkts Rx : 0
Checksum Error Pkts Rx : 0
Bad Version Pkts Rx : 0
Virtual Routers Respond To Ping Requests : Yes
VRRP Virtual Router Statistics Information
VLAN ID : 10
Virtual Router ID : 1
Protocol Version : 3
State : Master
Up Time : 26 mins
Virtual MAC Address : 00005e-000101
Master's IP Address : 2130::21
Associated IP Addr Count : 1 Near Failovers : 0
Advertise Pkts Rx : 0 Become Master : 1
Zero Priority Rx : 0 Zero Priority Tx : 0
Bad Length Pkts : 0 Bad Type Pkts : 0
Mismatched Interval Pkts : 0 Mismatched Addr List Pkts : 0
Mismatched IP TTL Pkts : 0 Mismatched Auth Type Pkts : 0
Using the debug command with the VRRP option
The vrrp option with the debug command turns on the tracing of the incoming and outgoing VRRP packets.
Syntax:
[no] debug vrrp
Chapter 16 Virtual Router Redundancy Protocol (VRRP) 335