HPE SimpliVity 2600 Gen10

Chapter 2: Install the chassis components 12
Chapter 2: Install the chassis components
This section contains the following topics:
• Electrostatic discharge
• Shipping carton contents
• Components not supplied in the shipping carton
• Rack requirements
• Rack installation guidelines
• Install the chassis in a rack
• Connect the power cables
• Connect the network cables
• Power up the server
To install the chassis components, you must unpack all components, install the chassis in a rack, connect the
power and network cables, and power on the system.
Electrostatic discharge
You must protect sensitive components from electrostatic discharge (ESD).
To protect components from ESD:
• Ensure the component is fully grounded at all times to prevent damage from electrostatic discharge.
• When not installed in a rack, store server components in the original packaging or place on a sturdy surface
that is protected from electrostatic discharge.
• When handling server components, always use the electrostatic wrist strap provided or a similar form of ESD
protection.
Shipping carton contents
The shipping carton contains standard items and other items based on your configuration.
Part Description
Chassis HPE SimpliVity 2600 chassis.
Servers (two, three, or four) Provide processing power and storage capacity.
Power cords • Two standard power cords that meet one of the following
specifications based on power requirements:
• Two IEC C13/C14 (PDU) cords.
• Two IEC C15/16 (PDU) cords - for customers ordering an
1800W-2200W power supply.