HPE SimpliVity 2600 Gen10

Chapter 1: Component identification 11
Specifications
This section provides environment and technical specifications for HPE SimpliVity 2600 Gen10 servers.
The specifications help you when planning the appropriate installation location, environmental conditions,
and resources such as power and cooling. See the product QuickSpec for the latest information on system
specifications.
Vibration and shock
The server configured for deployment in a HPE OmniStack federation does not exceed the vibration and shock
limit specifications for a fully-configured server.
Agency compliance
HPE SimpliVity 2600 Gen10 servers, when configured for deployment in an HPE OmniStack federation, meet the
same compliance standards as standard HPE Apollo Gen10 servers.
Component upgrades
If you need to upgrade the server components, contact Customer Support (support.hpe.com).
WARNING:
Never install additional options other than those approved for installation by Customer Support
(support.hpe.com). Doing so will void your warranty and might cause serious server instability and
potential data loss.
Firmware revisions
HPE OmniStack software requires that each supported platform is running a specific firmware revision.
To avoid compatibility issues, contact Customer Support (support.hpe.com) before making any firmware
changes.
NOTE:
If your server, or any management software, has automatic software updates enabled, disable this feature to
avoid installing unsupported firmware revisions.