Securing the drive
Procedure
1. Slide the tape drive fully into the drive bay.
2. If the drive is secured with clips, verify that they are engaged and that the drive is secure.
If the drive is secured with fasteners, use a PoziDrive #1 screwdriver to secure the 4mm M3 screws
provided with the tape drive.
If the server sheet metal is less than 1.5mm thick, use the screws and washers provided in the
GENERAL MOUNTING SCREWS screw pack so the screws can be tightened without damaging the
drive. (The washers are not needed if the server sheet metal is at least 1.5mm thick.)
3. Cover any empty bays with blanking plates and then replace the cover on the server.
12 Securing the drive
To Next Page
Loading...
