Procedure
1. In the Navigator select SNMP from Device Configuration.
2. In the SNMP Agent Setup pane, click Modify.
3. In the Modify SNMP Agent window, change the State to On and modify other parameters, as
required.
4. Click OK.
5. Use the bottom half of the page to configure SNMP Trapsinks and SNMP Users. For more
information about the information shown on the SNMP Trapsinks and SNMP Users tabs, see the
Online Help or the user guide for your product.
Setting up SNMP (Simple Network Management Protocol) 47
To Next Page
Loading...
