HPE StoreOnce 3100

Setting up SNMP (Simple Network
Management Protocol)
Management Information Bases (MIBs)
Two MIBs are used to represent the information handled by the StoreOnce System and they are called
SEMI-MIB.mib and TRAP-DESTINATIONS-MIB.mib. These must be downloaded and registered with the
Network Management application on the host, so that information from the StoreOnce System can be
transmitted to and interpreted by the Network Management host, such as Insight Remote Support.
If this is the first StoreOnce System to be added to the network, you must download the MIBs,
Management Information Bases and register the MIBs with the Network Management application. You
can then use the StoreOnce CLI or StoreOnce GUI to set up the SNMP agent, for example with system
contact details, and to configure trap sinks and users.
When you connect subsequent StoreOnce Systems to the network, you only need to update the MIBs if
they are later models. For example, once you have downloaded the MIBs associated with StoreOnce
Systems, those MIBs are valid for all subsequent StoreOnce Systems and any earlier models that are
monitored by the Network Management application.
Setting up the Network Management application for use
with the StoreOnce System
Procedure
1. To download the MIBs, go to the HPE Support website at http://www.hpe.com/support and search
for your StoreOnce System. Select the Software and driver downloads option and OS Independent
for the operating system. The MIBs are included under the MIB entry.
2. To set up the Network Management application for use with the StoreOnce System:
a. Register SEMI-MIB.mib and TRAP-DESTINATION-MIB within the base of MIBs supported by the
Network Management application.
b. Update the existing system type database with the new system type for the StoreOnce System,
based on the unique system object identifier.
c. Discover the StoreOnce System under the Network Management application.
For further information about setting up the Network Management application, refer to the MIB release
notes and to the documentation supplied with the Network Management application.
Configuring SNMP on the StoreOnce GUI
The default state at installation and after QR is off. SNMP may be enabled and configured from the
StoreOnce GUI or the StoreOnce CLI.
If you prefer to configure SNMP using StoreOnce CLI commands, refer to the StoreOnce CLI Reference
Guide.
46 Setting up SNMP (Simple Network Management Protocol)