Name Description
IP address The IP address for the subnet, in the appropriate format for
the protocol selected.
Default Subnet When checked, this box indicates that this is the Subnet that
contains the default gateway. A default subnet should be
provided for both IPv4 and IPv6 networks.
Network Mask (IPv4 only) The network mask
Prefix (IPv6 only) The network prefix in CIDR format
Domain Name The domain name
VLAN tag The VLAN tag ID (2 to 4096)
2. Provide the Subnet details, and then click OK.
• For IPv4 Subnets, select the IPv4 button and provide the relevant details.
• For IPv6 Subnets, select the IPv6 button and provide the relevant details.
DHCP Subnets may support both IPv4 and IPv6 protocols.
3. Repeat until all the Subnets for the selected Port Set have been defined.
Each physical Port Set may be configured with one Subnet that uses the IPv4 protocol and one
Subnet that uses the IPv6 protocol.
If the Port Set is VLAN enabled, it is possible to add a total of 128 IPv4 and 128 IPv6 VLAN Subnets.
These total values apply across the whole network configuration, not per Port Set.
If DHCP is used, one IPv4 and one IPv6 subnet will be consumed.
4. Click Save to save all configuration details.
Validating and activating the StoreOnce configuration
Procedure
1. Click Validate to validate the network configuration. If there are any errors, the error message will
guide you to the parts of the configuration that need correcting. Make the necessary changes, save
them and click Validate again.
2. If validation is successful, you have two choices. The StoreOnce System Management GUI will prompt
you to activate the new configuration immediately. Or you can save it and activate it separately from
the Network Configuration — Custom page.
NOTE:
It is not possible to activate a new configuration if storage addition is in progress.
Validating and activating the StoreOnce configuration 61
To Next Page
Loading...
