Field name Description
Protocol: IPv4 or IPv6 The radio button selected defines the Internet
Protocol for the DNS servers.
DNS Address 1/2/3 Up to three IPv4 and/or IPv6 DNS addresses
may be defined. The format of the address
details is as appropriate for the protocol selected.
In order to use FQDNs “Fully Qualified Domain
Names” rather than an IP address to access the
StoreOnce System, the DNS server addresses
that you provide should be able to resolve
addresses for all configured subnets. If you are
using IPv4 and IPv6 addressing, then DNS
servers configured need to be able to resolve
both IPV4 and IPV6 FQDNs. Up to three DNS
servers (one primary, and two backup servers if
the primary is unavailable) may be configured for
the StoreOnce System, which have IPv4 and/or
IPv6 addresses.
Creating portsets
Procedure
1. On the Port Set bar click Add to create the first Port Set.
2. Enter a name for the Port Set and select the ports to use. Available ports depend upon the model of
StoreOnce System and whether ports have already been assigned. Only those ports that are available
are active for selection; others are greyed out if they are already in use.
3. Some hardware products support optional PCI-E cards for 10 Gbit Ethernet. If your system has these
cards installed, they are included in the Ports section with the network type clearly indicated.
See Optional PCIe cards on page 76 for more information about optional hardware.
4. Click on the Show Port Picture link to display a picture of the rear of the model with ports labeled.
58 Creating portsets
To Next Page
Loading...
