HPE StoreOnce 3100

Expanding storage capacity, if supported
HPE StoreOnce 3500 Series
The HPE StoreOnce 3500 Series does not support the addition of storage expansion enclosures. It is
supplied with 12 disks installed. The StoreOnce 3540 model is supplied with twelve 4 TB disks installed;
the StoreOnce 3520 model is supplied with twelve 2 TB disks installed. The base configuration for both
models uses 50% of the available capacity (24 TB or 12 TB).
• If configured in the factory for the full capacity of 48 TB (3540 model) or 24 TB (3520 model), all
storage will already be licensed and is available for use without any further action.
• If not factory configured, the license entitlement will be delivered to the user via email. To complete
configuration of the storage, redeem the license and use the StoreOnce GUI to apply it. The expanded
storage is available for use; no further configuration is required.
Viewing license details
Procedure
1. Click Device Configuration in the Navigator pane. Select License Management.
2. Verify that there is a license for the Capacity Upgrade Kit.
3. If the license is missing, see StoreOnce full license on page 37 for information about applying
licenses.
Once the license is applied, the storage is available for use.
Viewing storage status
Procedure
1. Click Storage in the Navigator pane. Select the Storage Configuration tab.
An Information dialog box will appear that tells you to click Scan for Storage.
50 Expanding storage capacity, if supported