What to do if hpmont HD5L-4T7P5 displays E0012 error?
If the hpmont Controller displays error E0012, indicating a motor auto-tuning fault, check the motor connection and input correct nameplate parameters.
What to do if hpmont HD5L-4T7P5 displays E0013 error?
If the hpmont Controller displays error E0013, which indicates soft start contactor failed, replace the contactor.
General| Brand | hpmont |
|---|---|
| Model | HD5L-4T7P5 |
| Category | Controller |
| Language | English |
Details restrictions on output side connections, voltage, and input phase usage.
Lists detailed electrical, performance, characteristic, and protection specifications.
Provides a table of models, power ratings, input/output currents, and motor power.
Outlines essential safety precautions before and during controller installation.
Specifies environmental and spatial requirements for controller installation.
Lists critical safety precautions and guidelines for electrical wiring.
Covers terminal descriptions and wiring practices for the main power circuit.
Explains wiring precautions and general connections for the control circuit.
Provides guidelines for installation to meet EMC standards and reduce interference.
Defines the four modes for receiving run commands and setting speed.
Explains the five available running modes for the controller.
Provides step-by-step examples for setting parameters and managing user passwords.
Guides the user through the initial power-on and controller initialization process.
Outlines basic steps for system analysis, wiring, and parameter setup.
Provides a table listing fault codes, possible causes, and countermeasures.
Lists basic parameters with their attributes, default values, and ranges.
Lists parameters for parameter protection with their attributes and default values.
Lists start/stop parameters with their attributes and default values.
Lists acceleration/deceleration parameters with their attributes and default values.
Lists speed parameters with their attributes and default values.
Lists asynchronous motor parameters with their attributes and default values.
Lists speed-loop parameters for vector control with attributes and default values.
Lists synchronous motor parameters with their attributes and default values.
Lists PG (encoder) parameters with their attributes and default values.
Lists digital I/O terminal parameters with their attributes and default values.
Lists analogue I/O terminal parameters with their attributes and default values.
Lists fault protection parameters with their attributes and default values.
To Next Page
