How to resolve error E32 on hpmont HD5L-PLUS Controller?
To resolve error E32 on the hpmont Controller, set proper encoder pulse number if there is an encoder pulse number setting error. If the controller torque is inadequate, select bigger capacity controller. Also, if the speed-loop PI parameter setting is incorrect, correctly set speed-loop PI parameter.
What to do if hpmont Controller shows error E08?
If your hpmont Controller displays error code E08, it indicates a potential issue with the output. Check for a short circuit between phases output or the ground, and ensure the wires are properly connected. Also, verify if the output current is too high and inspect the connection and mechanism. If the power module is damaged, contact the supplier for repairing.
What causes error E04 on hpmont HD5L-PLUS Controller and how to fix it?
Error E04 on your hpmont Controller can be triggered by several factors. It may be due to input voltage being too high, so check the power input. Additionally, a too-short Dec. time can cause this, so set a proper value for Dec. time. Improper wiring leading to overvoltage of hardware can also be a cause, so check wiring and wire HD5L-PLUS properly.
Why does hpmont HD5L-PLUS show error E09?
The E09 error on the hpmont Controller typically indicates an overheating issue. This might be because the ambient temperature is too high, so use a controller with higher power capacity. Poor external ventilation of HD5L-PLUS could also be the cause, so improve the ventilation around HD5L-PLUS. Check if the fan is working correctly and replace the cooling fan if it’s faulty. If the fault occurs to temperature detection circuit, seek technical support.
How to troubleshoot E01 error on hpmont Controller?
To troubleshoot an E01 error on your hpmont Controller, consider these steps: * Ensure the connection between the controller and motor is properly established by connecting HD5L-PLUS and the motor correctly. * Verify that the motor parameters are correctly set. * If the rating of the used HD5L-PLUS is too small, select a controller with a higher rating. * Also, check that the Acc./Dec. time is appropriately set; adjust if it's too short.
How to fix E28 error on hpmont Controller?
To fix the E28 error on your hpmont Controller, check the connection of the communication cable for any faults. If disconnected or not well connected, further diagnosis is needed.
What does E14 error code mean on hpmont Controller?
If your hpmont Controller is showing the error code E14, it means that the current detection circuit is damaged, so contact the supplier for repairing.
What does error E25 mean on hpmont Controller?
The error E25 on the hpmont Controller may be due to an improper setting of F16.14, F16.15, so correct the setting of F16.14, F16.15. Also, check the connection between HD5L-PLUS and motor. Detect HD5L-PLUS whether output and detect whether the output contactor work is normal.
How to fix error E16 on hpmont HD5L-PLUS?
To address error E16 on the hpmont Controller, check the connection between HD5L-PLUS and the motor for output voltage phase disconnection or loss. Also, if the three-phase load of HD5L-PLUS is severely unbalanced, check the quality of motor.
How do I fix E18 error on hpmont HD5L-PLUS Controller?
To resolve the E18 error on your hpmont Controller, consider the following: * If there is a brake fault or contactor fault, change contactor. * If there is a PG pulse number fault, set proper PG P/R. * If there is an improper setting of F05.19, F05.20, correct the setting of F05.19 - F05.20. * If the controller torque is inadequate, select bigger capacity. * If the speed-loop PI parameter setting is incorrect, correctly set speed-loop PI parameter.
General| Brand | hpmont |
|---|---|
| Model | HD5L-PLUS Series |
| Category | Controller |
| Language | English |
To Next Page
