Chapter 1 Safety Information and Precautions Shenzhen Hpmont Technology Co., Ltd.
2 HD5L-PLUS Series User Manual V1.0
Requirement for Leakage Current Protector RCD
Since the device generates high leakage current which goes through the protective grounding
conductor, please install B type leakage current protector RCD on one side of the power supply.
For the selection of RCD, users need to consider the possible problems of ground leakage current in
both transient status and steady status at start and during running. It is recommended to choose
either special RCD that can suppress the higher harmonics, or general RCD that has more aftercurrent.
Warning for Ground Mass Leakage Current
The device generates mass leakage current, so users need to confirm the reliable grounding before
connect to the power supply. The grounding should comply with the local relative IEC standard.
1.3 About HD5L-PLUS
No Capacitor or Varistor on the Output Side
Since HD5L-PLUS output is PWM wave, it is strictly forbidden to connect capacitor for improving the
power factor or varistor for lightning protection to the output terminals so as to avoid HD5L-PLUS fault
trip or component damage.
Contactors and Circuit Breakers Connected to The Output of HD5L-PLUS
If circuit breaker or contactor needs to be connected between HD5L-PLUS and the motor, be sure to
operate these circuit breakers or contactor when HD5L-PLUS has no output, so as to avoid any damage
to HD5L-PLUS.
Running Voltage
HD5L-PLUS is prohibited to be used beyond the specified range of running voltage. If needed, please
use the suitable voltage regulation device to change the voltage.
Capacitor Energy Storage
When the AC power supply is cut off, capacitor of HD5L-PLUS sustains deadly power for a while. So to
disassemble HD5L-PLUS that is powered, please cut off the AC power supply for more than 10 minutes,
confirm the internal charge indicator is off and the voltage between (+) and (-) of the main circuit
terminals is below 36V.
Generally, the internal circuit enables the capacitor to discharge. However, the discharging may fail in
some exceptions. In these cases, users need to consult Hpmont or our regional distributor.
Change Three Phase Input to Single Phase Input
For three phase input controller, users should not change it to be single phase input.
To use single phase power supply, disable the input phase-loss protection function. And the bus-
voltage and current ripple will increase, which not only influences the life of electrolytic capacitor but
also deteriorates the performance of the controller. In that case, the controller must be derating and
should be 60% within rated value of controller.
Lightning Surge Protection
HD5L-PLUS internal design has lightning surge overcurrent protection circuit, and has certain self-
protection capacity against the lightning.
To Next Page
Loading...
Need help?
General
