- 15 -
g)
The use of
power tools for anything other than the intended applicaon can lead to dangerous
situaons.
h) Slippery
handles and gripping surfaces do not allow safe operaon and control of the power
tool in unforeseen situaons.
i) Do not use under-performing tools for heavy loads. Do
not use tools for purposes and work for which they are not intended.
j) Before connued use of the tool safety equip-
ment must be tested for proper and intended funcon. Check whether the
funcon of moving parts is okay, whether they do not jam, whether any parts
are broken, whether all other parts funcon properly and whether all condi-
ons which must be met for the proper operaon of the device have been met.
Damaged protecve devices and parts should be properly repaired or replaced by
trained customer service unless otherwise specied in this operang instrucons.
Damaged switches must be replaced by a customer service workshop. Do not use any
tools which cannot be properly switched on and o using the start buon.
a)
There is a risk of re if the baery is used on an unsuitable charger and
the baery can be permanently damaged.
b) The use of other
baeries can lead to injuries and the risk of re.
c)
-
A short circuit between the baery contacts can lead to
burns or re.
d)
Leaking baery uid can lead to skin irrita-
ons or burns.
To Next Page
Loading...
