HS-Technik NutBee NBLS-21 - Overload; Standby and Shut-Down Mode

- 32 -
4.2.14 Overload
In order to avoid damages as a result of excess temperatures during connuous operaon
it is important to observe sucient break mes during the installaon process.
If the tool should go into an automac shut-down (TEMP FET)
as a result of excess temperatures the break mes should
be reviewed and adjusted.
Connued work is only possible aer a cooling o period in order to protect the tool from
lasng damage.
 
Aer approx. 10 minutes without actuaon → the tool switches to standby mode
The tool starts up again by briey tapping on the start buon.
Aer another approx. 30 minutes without actuaon → automac shut-down
Start-up by pressing the start buon if the baery has not yet been removed or right
aer sliding the baery back on. Both are only possible if the baery has sucient charge
capacity.
NOTE
In the case of longer period of non-use (longer than 3 hours) the batter must
be separated from the tool in order to prevent deep discharge of the battery.
TEMP FET
STOP