HS-Technik NutBee NBLS-21 - Operation; Inserting and Removing the Battery

- 22 -
 
 
• In order to insert the baery (1), align it so that it can be easily pushed onto the mount-
ing provided along the plasc guide. Aer sliding it on completely, the fastening clip (2)
must lock the baery rmly and properly into place in the tool housing.
• In order to remove the baery push the fastening clip on the front side of the baery
down and pull the baery forward and o.
• Don't use force to install the baery. If the baery can not be easily pushed on it was not
correctly posioned.
NOTE
Always push the battery all the way in until it locks into place with a click.
WARNING

If the battery is not correctly locked it can fall out and cause injuries.
• Always ensure that the battery is fully locked into place.
1 - Baery
2 - Fastening clip
1
2