HS-Technik NutBee NBLS-21 - LED Indicator at the Back and Sound Signals; OLED Display

- 24 -
 

• Set stroke or set force was reached.
• The baery capacity is sucient, the tool is ready for the next seng.

• NOK riveng, tolerance + or - from set stroke or set force
• If the indicator blinks yellow-red mulple mes aer seng then the baery is almost
empty.
* - LED Light indicator
NOTE
The tool will only start after a battery change if the battery has sufficient capacity.
 
• Aer a suciently charged baery has been pushed on the tool will start.
• Aer pressing the start buon, the tool is inialised. The back, circumferenal indicator
briey lights up with mulple colours. A beep sounds and on the back of the tool the
display indicates the current status.
• The tool is now ready for use.
• Aer several seconds without actuaon the display will dim. Aer longer downme the
tool will switch into standby mode.
*
1. Buon for menu acvaon and selecon as well as for
the NOK conrmaon
2. Buon for decreasing value (-)
3. Buon for increasing value (+)
4. State of charge display
19320019
Service B
2
1
3
4
P01 000/001
ready
HandMode