HS-Technik NutBee NBLS-21 - Display Notifications

- 34 -
4.2.17 
  
17.44 V
batt low 1
Undervoltage warning,
Baery empty (ba low 1)
Change / charge baery
Baery empty (ba low 2)
Tool is not working anymore
Change / charge baery
Excess temperature „FET“ Let the tool and baery cool down
Hardware error
(Defect on motor,
Sensor, etc.)
Tool must be serviced
Thread pin must be replaced Replace thread pin
19320019
Service B
Maintenance service counter Tool must be serviced
19320019
Service A
Complete overhaul service
counter
Tool must be serviced
NOTE
In cases of serious faults corresponding notifications will appear in the
display. The tool must be sent to the manufacturer.
17.02 V
BATT LOW 2
TEMP FET
STOP
FAIL MOTOR
STOP
19320019
Service C