73
4.4.1.3
Inspection and Maintenance of fore bridge:
1. If the dust-proof Rubber Sheath of the transmission shaft is
worn out or cracked, please have it replaced immediately.
2、Check whether the ball is running smoothly. If found loosen or
stunk, replace the transmission shaft.
3、 disassemble the transmission shaft, clean then install,
Caution: 1. the dust-proof Rubber Sheath can not be touched
by petrol and diesel oil.
2 The dust-proof Rubber Sheath must not be
cracked for slight scratch may be damaged the
Rubber Sheath.
3. Inject 2/3 Lithium Lubrication into the ball.
4、Open the differential, and inspect wear condition of gear, shaft and
cushion, then replace the defective component.
4.4.1.4
assembly of fore bridge component
1、Fix transmission shaft onto fore bridge differential. ( Figure
4-2-19)
2、Inject 0.32L of Gear Lubricant of SAE 80 API GL-4 into
Fore bridge differential. Then tighten the bolt.
To Next Page
Loading...