HTC DURATIQ Information about the machine
18 www.htc-floorsystems.com
D002998, 01.06
3.5 Hand and arm vibrations
Hand and arm-weighted vibration levels [m/s
2
] for HTC DURATIQ have been measured using
equipment approved in accordance with ISO 5349-1:2001. The uncertainty of measurement
for the measuring equipment is given as ±2%.
The machine has been tested in accordance with ISO 5349-2:2001 and ISO 20643:2005 in
order to identify the operations that contribute to the most frequent vibration exposures. At
vibration levels > 2.5 m/s
2
the exposure time should be limited in accordance with the table
below. For vibration levels > 5 m/s
2
immediate measures must be taken by the employer to
ensure that the exposure time does not exceed the time specified in the table below.
Identified work conditions
Measured values [m/s
2
]
Daily permitted exposure
(number of hours)
Grinding/polishing
< 2.5 m/s
2
> 10 h
3.6 Sound power level
This machine has been tested for noise in accordance with ISO 3744:2010 and ISO 11201.
Measured using class 1 instruments as sound level meters. For information about sound level
power, see chapter Technical Data page 65.
To Next Page
Loading...
