HTC DURATIQ Accessories
D002998, 01.06
www.htc-floorsystems.com 47
7.2 Radio Control
Lock/Release Wheel Locking
See Locking the Wheels page 46.
Battery Disconnector
Switch on the battery disconnector, see Charging page
45.
Remote Control
Ensure that the emergency stop switch (5) is disconnected
as well as that the D-P-R control is in position P and the
grinding switch is in position 0.
Turn the button On/Off (6) and wait for the display on the
remote control to start up.
Check the battery level (7) by the display. In the case of low
battery level, change battery. The battery is charged in the
machine, see Storage compartment page 22
Control Panel
Press the button for radio communication (1) on the control
panel.
The lamp by the button (2) and the symbol on the display (3)
on the control panel lights up.
Remote Control
Press the button for radio communication (8), a contact is
now created between the remote control and the machine.
When the radio communication is created, the flashing
frequency on LED (7) increases to 1/sec.
The machine is now in radio mode and, on the control
panel, only the emergency stop switch (4) and the radio
button (1) function.
To Next Page
Loading...
