HTC DURATIQ T6 - Prior to each New Grinding Process; Daily; Every Week; Repairs

HTC DURATIQ Maintenance and repair
D002998, 01.06
www.htc-floorsystems.com 57
• Always clean the machine after use. Only use high-pressure washer on grinding head and
hose and sponge on the rest of the machine.
• Vacuum clean the electrical cabinet, cooling fan and cooling flange.
8.3 Prior to each new grinding process
• Check the tool holder and grinding holder to ensure that no damage or cracks have
arisen. Replace parts, if there is any damage.
8.4 Daily
• Check the emergency stop function.
• Check the radio's emergency stop function.
• Check for wear to the grinding tools – abnormal or uneven wear may indicate a damaged
grinding holder.
• Check the tool holder and grinding holder to ensure that no damage has arisen. Replace
the parts, if there is any damage.
• Check the connection of hose and cables. Adjust if necessary.
8.5 Every week
• Clean machine and remote control.
• Check the handle's three different locking functions. Replace the bushes, if necessary.
• Check the locking function of the weights and the function of the positioning blocks,
replace if necessary.
• Check the grinding holders.
• Check warning decal.
• Check the fastening between chassis and grinding head – gap, wear, dry cracks. Replace
the bushes, if necessary.
• Check the grinding cover – seal, wear, cracks, brush list, extraction, hoses, couplings.
• Electrical cabinet – check seals.
• Electrical cables – check wear and attachment.
• Check the radio's rubber bellows on the joystick and switches. Replace, if necessary.
8.6 Repairs
All repairs that may need to be performed must be done by one of the HTC authorised
service centres. Contact your retailer if your machine requires servicing. For contact
information, see the start of the manual.