7.3.1 Obtaining the Site Management Rights
This section describes how to obtain the site management rights. Before configuring the base
station boards and logical objects, you must obtain the site management rights after logging into
the base station at the local end.
7.3.2 Configuring Base Station Boards
This section describes how to configure RF units and other boards of the base station on the
SMT.
7.3.3 Configuring BTS Logical Objects
This section describes how to configure logical objects of the BTS. The BTS logical object
configuration consists of the cell configuration, carrier binding, and activation of cell
configuration data.
7.3.1 Obtaining the Site Management Rights
This section describes how to obtain the site management rights. Before configuring the base
station boards and logical objects, you must obtain the site management rights after logging into
the base station at the local end.
Prerequisite
You have logged in to the base station through the SMT.
Procedure
Step 1 In the Site Maintenance Terminal System window, select Site, and double-click Site
Management Right.
The Site Management Right dialog box is displayed.
Step 2 Click Obtain. The Warning Message dialog box is displayed, as shown in Figure 7-5.
Figure 7-5 Warning Message dialog box
Step 3 Click OK, and wait for the response.
l If the site management rights are successfully obtained, a dialog box is displayed, as shown
in Figure 7-6.
l If failed, the probable cause is that engineers are configuring or managing base station data
on the LMT side. Wait till the operations are complete and then perform Step 2 and Step
3.
7 Commissioning the MBTS by Using Local Maintenance
Terminal and M2000
3900 Series Multi-Mode Base Station
Commissioning Guide
7-10 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 02 (2010-07-30)
To Next Page
Loading...
Need help?
General
