Huawei AR120 Series - Page 109

Step 3 Perform the following steps depending on whether slots are combined:
l When no slots are combined:
NOTE
The methods for installing SIC, WSIC, and XSIC cards into SIC, WSIC, and XSIC slots are the
same. The following procedures install a SIC card into a SIC slot.
a. Rotate the ejector levers outward and slide the card into the slot horizontally along
the guide rails until the card panel is closely attached to the router panel.
b. Rotate the ejector levers inward until the card is completely seated in the slot, and
then tighten the captive screws on both sides of the card.
a b
l When slots are combined:
NOTE
Slots of a router can be combined into a larger slot. For example, two SIC slots can be combined
into a WSIC slot, and two SIC slots and the WSIC slot below them can be combined into an XSIC
slot. In this example, two SIC slots are combined into a WSIC slot.
a. Loosen the captive screw on the guide rail between the two SIC slots.
b. Remove the guide rail to combine the two SIC slots into a WSIC slot.
c. Slide the WSIC card into the WSIC slot horizontally along the guide rails until the
card is completely seated in the slot. Rotate the ejector levers inward to lock the
card in the slot, and then tighten the captive screws on both sides.
Huawei
AR100&AR120&AR150&AR160&AR200&AR1200&AR
1600&AR2200&AR3200&AR3600 series Enterprise
Routers
Hardware Installation and Maintenance Guide
7 Installing AR2240/AR2240C/AR3260/AR3670 Routers
Issue 05 (2018-07-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
103