Huawei AR120 Series - Installing Fiber Connectors; Cleaning Fiber Connectors; Installing an FC Fiber Connector

To Next Page

To Previous Page

Step 4 To remove an Ethernet connector, press the locking key and pull out the connector, as shown

in Figure 9-57.

Figure 9-57 Removing an unshielded Ethernet connector

----End

9.2.4.4 Installing Fiber Connectors

Context

NOTICE

l After you remove the dustproof cap, ensure that the fiber pins are clean and install them as

soon as possible.

l When you disassemble fiber connectors, you must use a dedicated tool if the connectors

are densely installed.

9.2.4.4.1 Cleaning Fiber Connectors

Procedure

Step 1 Clean the pins of a fiber connector by using lint-free cotton and alcohol.

Step 2 Clean the pins again by using dust-free cotton. If necessary, clean the pins by using an air gun.

Ensure that the pins are free from any fiber or debris.

----End

9.2.4.4.2 Installing an FC Fiber Connector

Huawei

AR100&AR120&AR150&AR160&AR200&AR1200&AR

1600&AR2200&AR3200&AR3600 series Enterprise

Routers

Hardware Installation and Maintenance Guide

9 Appendix

Issue 05 (2018-07-30) Huawei Proprietary and Confidential

169

Other manuals for Huawei AR120 Series