Huawei AR120 Series - Page 121

l Marker
l Network cables (separately purchased)
l Network cable labels
Procedure
Step 1 Select Ethernet cables of appropriate quantity and lengths according to the number of ports
and measured cabling distances.
Step 2 Attach temporary labels to both ends of each Ethernet cable and write numbers on the labels
to identify the Ethernet cables. For details, see 9.5.3 Engineering Labels for Network
Cables.
Step 3 Lead the Ethernet cables into the cabinet from the top cable inlet (for overhead cabling) or
bottom cable inlet (for on-ground cabling), and route the cables from one side of the cabinet.
Step 4 Connect one end of an Ethernet cable to an Ethernet interface of the router and the other end
to an Ethernet interface of the remote device.
AR2200 Series
FAN
STATUS
10PWR 9PWR
11 SRU
F
A
N
12
STAT US
ON
OFF
~100-240V;50/60Hz;5A
PWR350A
ACT
micro SD
SYS ACT
LINK0 LINK1
ACT0 ACT1
EN EN
CON/AUX RST
GE1
GE0
GE1 GE2
SRU40
GE2
Network cable
Ethernet interface of
the remote device
Step 5 Arrange the Ethernet cables to make them parallel, and then bundle them with cable ties. Use
diagonal pliers to cut off redundant cable ties.
Step 6 Remove the temporary labels from the Ethernet cables, and then attach formal labels 2 cm
away from the connectors at both ends.
----End
Follow-up Procedure
Check the following items after connecting Ethernet cables:
l Labels are correctly filled and securely attached to cables, with texts facing the same
direction.
Huawei
AR100&AR120&AR150&AR160&AR200&AR1200&AR
1600&AR2200&AR3200&AR3600 series Enterprise
Routers
Hardware Installation and Maintenance Guide
7 Installing AR2240/AR2240C/AR3260/AR3670 Routers
Issue 05 (2018-07-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
115