Applicable Environment
Before configuring SIP AG service features, configure the AR1200 to work in SIP AG mode.
You can run the display voice service-mode command to view the working mode of the
AR1200. If the AR1200 works in SIP AG mode, skip this configuration.
Pre-configuration Tasks
Before configuring the AR1200 to work in SIP AG mode, complete the following task:
l Configuring IP addresses and routing protocols for interfaces to ensure connectivity
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
voice
The voice view is displayed.
Step 3 Run:
service-mode sipag
The AR1200 is configured to work in SIP AG mode.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
quit
Return to the user view.
Step 6 Run:
save
The configuration is saved.
Step 7 Run:
reboot
The AR1200 is restarted.
NOTE
After the AR1200 is configured to work in SIP AG mode, restart the AR1200 to make the configuration
take effect.
----End
Checking the Configuration
After the configuration is complete, the AR1200 works in SIP AG mode.
Run the display voice service-mode command to check the working mode of the AR1200.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6
To Next Page
Loading...
