Huawei AR1200 Series - Checking the Configuration

Function/Service Command Default Setting
UUS3 service uus3 { enable | disable } disable
----End
1.7.5 Checking the Configuration
Procedure
l Run the display voice sipaguser [ sipaguser-name ] command to check the configuration
of the SIP AG user.
l Run the display voice sipag usergroup name command to check information about user
group huawei.
l Run the display voice servicedata [ name | sipaguser sipaguser-name telno-value ]
command to check service data in the SIP service data profile.
----End
Checking the Configuration
After the configuration of a SIP AG user is complete, you can view the configuration of the SIP
AG user.
Run the display voice sipaguser [ sipaguser-name ] command to check the configuration of the
SIP AG user.
<Huawei> display voice sipaguser 1
Slotid/Subcard/Portid : 2/0/0
MGID : 1
Base telno : 11111111
Usergroup name :
Extend telno :
Usergroup name :
Priority : cat3
Line type : DEL
CLIP transmission sequence : After ring
CLIP format : SDMF FSK
DC time : 100 ms
FSK time : 800 ms
VQE agc : Off
VQE sns : Off
VQE agc level : -22 dbm0
VQE sns level : 12 dB
DSP input gain : 0 dB
DSP output gain : 0 dB
DSP template :
Ans bar by single tone : Off
Bell ans flag : Off
FSK mode : BELL202
Fsk tas pattern : NO TAS
Run the display voice sipag usergroup name command to check information about user group
huawei.
<Huawei> display voice sipag usergroup huawei
Running state :
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
53