Huawei AR1200 Series - Optional) Setting Parameters for Voice Interfaces; Setting Parameters for an FXS Interface

Para index: 24 Value: 1
Para index: 25 Value: 0
Run the display voice sipag nte mgid command to check RFC 2833 redundancy transmission
information about the SIP AG.
<Huawei> display voice sipag nte 1
MGID : 1
RFC2833-negomode : no-initiative-start
RFC2833-fax-modem : enable
RFC2833-flashhook : disable
RFC2833-dtmf : enable
Run the display voice sipag redundancy mgid command to check RFC 2198 redundancy
transmission information about the SIP AG.
<Huawei> display voice sipag redundancy 1
MGID : 1
RFC2198-negomode : no-initiative-start
RFC2198-startmode : ordinary2198
RFC2198-red-2833 : disable
RFC2198-red-VBD : enable
RFC2198-red-voice : disable
Run the display voice sipag signal command to check the signal mapping list of the SIP AG.
<Huawei> display voice sipag signal
Signal list
test
1
1.5 (Optional) Setting Parameters for Voice Interfaces
This section describes how to set parameters for FXS interfaces and FXO interfaces.
1.5.1 Setting Parameters for an FXS Interface
This section describes how to set parameters for an FXS interface.
Applicable Environment
An FXS interface connects to a POTS phone. To achieve high transmission efficiency on an
FXS interface, properly set parameters for the FXS interface on the AR1200, including physical
attributes, electrical attributes, and KC attributes.
Pre-configuration Tasks
Before setting parameters for an FXS interface, complete the following task:
l Ensuring that the voice board is working properly
Data Preparation
To set parameters for an FXS interface, you need the following data.
No.
Data
1 Polarity reversal pulse level width, polarity reversal mode, and dialing mode
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
18