Huawei AR1200 Series - CLI Overview

No. Data
2 Current, impedance, send gain, and receive gain
3 High-level pulse width, low-level pulse width, KC accounting mode, and voltage
operating
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
voice
The voice view is displayed.
Step 3 Run:
port fxs slotid/subcardid/portid
The FXS interface view is displayed.
Step 4 Set physical attributes for the FXS interface.
l Run:
reverse-pole-pulse enable
The polarity reversal pulse function is enabled.
l Run:
reverse-pole-pulse level level-value
The polarity reversal pulse level width is set.
l Run:
polarity-reverse-mode { hard | soft }
The polarity reversal mode is set.
l Run:
clip-reverse-pole-pulse enable
The CLIP polarity reversal pulse function is enabled.
l Run:
dial-mode { dtmf | pulse | both }
The dialing mode is set.
l Run:
line-lock enable
Port locking is enabled.
l Run:
nlp-mode { disable | normal | ec-gain-adjust | enhance | reduce }
The non-linear processing (NLP) mode is set.
Step 5 Set electrical attributes for the FXS interface.
l Run:
electric current current-value
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19