Huawei AR1200 Series - Checking the Configuration

Parameter Command Remarks
Mapping between a call
scenario and a status code
status-code-mapping scene status-
code
After configuring the
status code of a call
scenario, reset the SIP
AG to make the
configuration take
effect.
MWI
subscrip
tion
function
MWI
subscription
function
subscribe mwi { enable | disable } By default, the MWI
subscription function is
disabled.
Register
status
subscription
function
subscribe reg { enable | disable } By default, the register
status subscription
function is disabled.
UA profile
subscription
function
subscribe ua-profile { enable |
disable }
By default, a UA
profile subscription
request is initiated by a
user group.
Codec priority, codec
value, and packetization
interval
user-defined-profile codec-priority
pri-value codec-value pt-value
If you change the
priority of a codec
value, priorities of
other codec values are
also changed.
Software parameter with
a specified sequence
number
user-defined-profile number-
parameter strpara-no strpara-value
Priority of a service type user-defined-profile service-priority
pri-value srvid-value
If you change the
priority of a service
type, priorities of other
service types are also
changed.
----End
1.4.4 Checking the Configuration
Procedure
l Run the display voice sipag [ { running | config } mgid ] command to check the
configuration of SIP AG parameters.
l Run the display voice voip-address command to check the signaling and media IP
addresses.
----End
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15