Huawei AR1200 Series - Setting SIP Stack Parameters

MWI mode : FSK with ring
Flash hook upper : 350 ms
Flash hook lower : 100 ms
Park feed : Enable
PCM : a law
Ring frequency : 25HZ
Ring ac amplitude : 50Vrms
Send checksum : Enable
Receive checksum : Enable
Run the display voice user-defined-ring command to check all the user-defined ring
information.
<Huawei> display voice user-defined-ring
First-ring Second-ring Third-ring
Index Ring Interval Ring Interval Ring Interval
0 0 0 0 0 0 0
1 200 100 6000 4000 8000 6000
2 0 0 0 0 0 0
3 0 0 0 0 0 0
4 0 0 0 0 0 0
5 0 0 0 0 0 0
6 0 0 0 0 0 0
7 0 0 0 0 0 0
8 0 0 0 0 0 0
9 0 0 0 0 0 0
10 0 0 0 0 0 0
11 0 0 0 0 0 0
12 0 0 0 0 0 0
13 0 0 0 0 0 0
14 0 0 0 0 0 0
15 0 0 0 0 0 0
Run the display voice clip command to check CLIP parameters in offhook or onhook state.
<Huawei> display voice clip
CLIP onhook parameters
DTAS level : -8.5dBm0
FSK level : -8.5dBm0
Channel seize bit : 300
Mark signal bit : 180
DTAS FSK interval : 250ms
DTAS duration : 100ms
CLIP offhook parameters
DTAS level : -15.5dBm0
FSK level : -8.5dBm0
Mark signal bit : 80
DTAS ack interval : 160ms
Ack FSK interval : 50ms
Run the display voice upward-bandwidth command to check the call restriction configuration
when the uplink bandwidth is insufficient.
<Huawei> display voice upward-bandwidth
The max upward bandwidth : 100000 kbit/s
The reserved bandwidth for emergency call: 1000 kbit/s
The used normal bandwidth : 0 kbit/s
The used bandwidth for emergency call : 0 kbit/s
1.6.2 Setting SIP Stack Parameters
This section describes how to set SIP stack parameters.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
31