Huawei AR1200 Series - Configuring a SIP AG User Group

Parameter Command Default Setting
Service
termination of
a specified SIP
AG user
endservice N/A
Extended
phone number
extend-telno telno-value [ groupname
groupname-value ]
No extended phone number
configured
FSK call
display mode
fsk-mode { BELL_202 | CCITT_V23 |
NTT }
BELL_202
FSK delay fsk-time fsk-time 10 ms
User type line-type { DEL | ECPBX | LCPBX |
PayPhone }
DEL
SIP AG user
priority
priority { cat1 | cat2 | cat3 } cat3
TAS mode of
CLIP
tas-pattern { NO-TAS | DT-AS } NO-TAS
UNI fault
reporting
function
uni-report { enable | disable }
NOTE
This command is valid only on VE1 and BRA
interfaces.
disable
Voice quality
enhancement
(VQE)
function
vqe-agc { enable | disable } disable
Target VQE
level
vqe-agc-level vqe-agc-level 13
VQE noise
suppression
vqe-sns { enable | disable } disable
Noise
suppression
level
vqe-sns-level vqe-sns-level 12 dB
----End
1.7.3 Configuring a SIP AG User Group
This section describes how to configure a SIP AG user group.
Procedure
Step 1 Run:
system-view
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
49