Huawei AR1200 Series - Resetting a SIP AG

MGID : 1
Groupid :
Register_uri_mod : alone
Uri :
Precinct_mode : local
Subscribe : enable
GroupName : ip123
Auth password mode : password
Auth username :
Auth password : ******
Run the display voice servicedata [ name | sipaguser sipaguser-name telno-value ] command
to check service data in the SIP service data profile.
<Huawei> display voice servicedata huawei
Servicedata name : huawei
SIPAG user name : huawei
Tel number :
Auth password mode : Password
Auth name :
Auth password :
Call hold : Enable
Three party : Enable
Conference : Enable
Call transfer : Enable
Call waiting : Enable
MaliciousCallIdentiFication : Disable
Mwi : Disable
Terminal port ability : Disable
Call diversion : Disable
Uus1 : Disable
Uus2 : Disable
Uus3 : Disable
Anonymous call : Disable
Hotline : Disable
Centrex number :
Centrex prefix :
Centrex dial : Dial directly
Mwi mode : Deferred
Hotline time(s) : 100
Hotline number :
Dial tone : Normal
CFB num :
CFNR num :
CFNR time(s) : 100
CFU num :
1.8 Resetting a SIP AG
This section describes how to reset a SIP AG.
Applicable Environment
To make modified SIP AG parameters take effect, reset the SIP AG.
Pre-configuration Tasks
Before resetting a SIP AG, complete the following task:
l Configuring a SIP AG interface and a SIP AG user
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
54