Huawei AR1200 Series - Page 22

Checking the Configuration
After the SIP AG configuration is complete, you can view the media and signaling IP addresses
and other parameters of the SIP AG interface.
Run the display voice voip-address command to check the signaling and media IP addresses.
<Huawei> display voice voip-address
IP type : Signal IP
Method : Static
Interface : GigabitEthernet0/0/1
IP address : 2.1.1.3
IP type : Media IP
Method : Static
Interface : GigabitEthernet0/0/1
IP address : 2.1.1.3
Run the display voice sipag [ { running | config } mgid ] command to check the configuration
of SIP AG parameters.
<Huawei> display voice sipag config 1
MGID : 1
Dynamic signalling IP address name :
Signalling IP : 1.1.1.1
Signalling port : 5060
Dynamic media IP address name :
Media IP : 1.1.1.1
Transfer mode : UDP
Primary proxy IP 1 : 2.2.2.2
Primary proxy IP 2 :
Secondary proxy IP 1 :
Secondary proxy IP 2 :
Primary proxy port : 5060
Secondary proxy port :
Primary proxy domain name :
Secondary proxy domain name :
Proxy address mode : IP
Home domain name : huawei.com
SIP profile index : 1: Default
Service logic index : 0: Default
Server Address DHCP option : 0: None
Description :
AG domain name :
Phone context :
Register URI :
Conference factory URI :
Subscribe to UA profile : Enable
Subscribe to reg state : Disable
Subscribe to MWI : Disable
SDP negotiation mode : Remote
Mode of supporting proxy dual-homing : Dual home
Proxy detection mode : Probe
Proxy refresh mode :
Run the display voice local-digitmap huawei command to check information about a digitmap
configured on the SIP AG.
<Huawei> display voice local-digitmap huawei
Name : huawei
Type : normal
Body : 8888xxxx
Run the display voice ringmode sipag mgid command to check the ringing mode of a SIP AG.
<Huawei> display voice ringmode sipag 1
MGID : 1
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
16