Huawei AR1200 Series - Page 23

Index : 3
Ring mode name : weew
CadenceRing : 0: Normal Ring 1:4
InitialRing : 4: Normal Ring (FSK) 1:4
Run the display voice sctp-protocol sipag { config | running } mgid command to check SCTP
stack parameters of the SIP AG.
<Huawei> display voice sctp-protocol sipag config 1
In streams : 33
Out streams : 33
Maximum rto value : 30000ms
Initial rto value : 1000ms
Rto alpha parameter : 12%
Rto beta parameter : 25%
Heartbeat interval : 10000ms
Valid cookie lifetime : 60000ms
Maximum init retrans : 8
Association maxretrans : 8
Path maximum retrans : 5
No congestion level : 40%
Low congestion level : 60%
High congestion level : 80%
Send checksum : crc32
Run the display voice sipag auth { config | running } mgid command to check authentication
information about the SIP AG.
<Huawei> display voice sipag auth config 1
SIP auth para
MGID : 1
Auth Mode : single-user
Password-mode : password
Auth-username : huawei
Auth-password : ********
Run the display voice sipag dtmf mgid command to check DTMF parameters of the SIP AG.
<Huawei> display voice sipag dtmf 1
MGID : 1
DTMF/MF transfers mode : thoroughly
Run the display voice sipag fax-modem mgid command to check fax and modem parameters
of the SIP AG.
<Huawei> display voice sipag fax-modem 1
MGID : 1
Nego-mode : negotiate
Rtp-interval : 10ms
Vbd-codec : G.711A
Vbd-pt-type : static
Vbd-attribute-type : V.152
FAX transmode : thoroughly
MODEM transmode : thoroughly
Run the display voice sipag mg-number-parameter mgid command to check parameter
indexes and values of the SIP AG.
<Huawei> display voice sipag mg-number-parameter 1
Para index: 0 Value: 0
Para index: 1 Value: 0
Para index: 2 Value: 0
Para index: 3 Value: 0
Para index: 4 Value: 0
Para index: 5 Value: 1
Para index: 13 Value: 0
Para index: 15 Value: 0
Para index: 23 Value: 600
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
17