Huawei AR1200 Series - Page 29

No. Data
7 CLIP parameters in offhook state:
l Interval between the time when the ACK message is received and the time when
the FSK is transmitted
l Maximum duration between the time when the DT-AS is transmitted and the time
when the ACK message is received
l Duration of the DT-AS
l Level of the DT-AS
l Level of the FSK
l Number of bits of the FSK synchronization mask
8
CLIP parameters in onhook state:
l Number of bits seized by a channel
l Duration of the DT-AS
l Interval between the time when the DT-AS is transmitted and the time when the
FSK is transmitted
l Level of the DT-AS
l Level of the FSK
l Number of bits of the FSK synchronization mask
9
Maximum uplink bandwidth and reserved bandwidth for emergency calls
Configuring a Country/Region Identifier
This section describes how to configure a country/region identifier.
Applicable Environment
A country/region identifier is configured on a SIP AG so that user terminals connect to the SIP
AG can comply with the local standard.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
voice
The voice view is displayed.
Step 3 Run:
country { brazil | britain-msfuk | britain-etsi | bulgaria | china-hongkong |
china-mainland | egypt | france | singapore | thailand }
A country/region identifier is configured.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
23