# Reset the SIP AG.
[Huawei-voice] sipag 1
[Huawei-voice-sipag-1] reset
Are you sure to reset MG interface?(y/n)[n]: y
[Huawei-voice-sipag-1]
Reset MG interface succeeds!
Step 4 Verify the configuration.
Then user terminals on the SIP AG can implement voice communication.
Run the display voice sipag [ { running | config } mgid ] command to view detailed information
about the SIP AG.
<Huawei> display voice sipag config 1
MGID : 1
Dynamic signalling IP address name :
Signalling IP : 1.1.1.1
Signalling port : 5060
Dynamic media IP address name :
Media IP : 1.1.1.1
Transfer mode : UDP
Primary proxy IP 1 : 2.2.2.2
Primary proxy IP 2 :
Secondary proxy IP 1 :
Secondary proxy IP 2 :
Primary proxy port : 5060
Secondary proxy port :
Primary proxy domain name :
Secondary proxy domain name :
Proxy address mode : IP
Home domain name : huawei.com
SIP profile index : 1: Default
Service logic index : 0: Default
Server Address DHCP option : 0: None
Description :
AG domain name :
Phone context :
Register URI :
Conference factory URI :
Subscribe to UA profile : Enable
Subscribe to reg state : Disable
Subscribe to MWI : Disable
SDP negotiation mode : Remote
Mode of supporting proxy dual-homing : Dual home
Proxy detection mode : Probe
Proxy refresh mode :
Run the display voice sipaguser [ sipaguser-name ] command to view detailed information
about the SIP AG users.
<Huawei> display voice sipaguser 1
Slotid/Subcard/Portid : 2/0/0
MGID : 1
Base telno : 11111111
Usergroup name :
Extend telno :
Usergroup name :
Priority : cat3
Line type : DEL
CLIP transmission sequence : After ring
CLIP format : SDMF FSK
DC time : 100 ms
FSK time : 800 ms
VQE agc : Off
VQE sns : Off
VQE agc level : -22 dbm0
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Voice 1 SIPAG Configuration
Issue 03 (2011-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
58
To Next Page
Loading...
