2. Run:
user-interface tty first-ui-number [ last-ui-number ]
The TTY user interface view is displayed.
3. Run:
authentication-mode password
The authentication mode is set to password authentication.
4. Run:
set authentication password { cipher | simple } password
The authentication password is configured.
l Configuring non-authentication
1. Run:
system-view
The system view is displayed.
2. Run:
user-interface tty first-ui-number [ last-ui-number ]
The TTY user interface view is displayed.
3. Run:
authentication-mode none
The authentication mode is set to none.
----End
4.4.6 Checking the Configuration
After configuring the TTY user interface, you can view information about the user interface,
physical attributes and configurations of the user interface, local user list, and online users.
Prerequisite
The configurations of the user management function are complete.
Procedure
l Run the display users [ all ] command to check information about the user interface.
l Run the display user-interface tty ui-number1 [ summary ] command to check physical
attributes and configurations of the user interface.
----End
Example
Run the display users command, and you can view information about the current user interface.
<Huawei> display users
User-Intf Delay Type Network Address AuthenStatus AuthorcmdFlag
0 TTY 0 00:00:44
Username : Unspecified
Run the display user-interface tty ui-number1 [ summary ] command, and you can view the
physical attributes and configurations of the user interface.
Huawei AR2200 Series Enterprise Routers
Configuration Guide - Basic Configuration 4 Configuring User Interface
Issue 02 (2011-10-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
50
To Next Page
Loading...
