Huawei AR2200 Series - Checking the Configuration

To Next Page

To Previous Page

2. Press "Enter" to display the command line prompt of the system view, such as

<HUAWEI>. This indicates that you have accessed the Telnet server.

----End

5.3.6 Checking the Configuration

After users log in to the system by using Telnet, you can view the connection status of the current

user interface, connection status of each user interface, and status of all established TCP

connections.

Prerequisite

Configurations of logins by using Telnet are complete.

Procedure

l Run the display users [ all ] command to check information about logged-in users on user

interfaces.

l Run the display tcp status command to check TCP connections.

l Run the display telnet server status command to check the configuration and status of the

Telnet server.

----End

Example

Run the display users command to view information about the currently-used user interface.

<Huawei> display users

User-Intf Delay Type Network Address AuthenStatus AuthorcmdFlag

34 VTY 0 00:00:12 TEL 10.138.77.38 no

Username : Unspecified

+ 35 VTY 1 00:00:00 TEL 10.138.77.57 no

Username : Unspecified

Run the display tcp status command to view TCP connections. In the command output,

Established indicates that a TCP connection has been established.

Huawei AR2200 Series Enterprise Routers

Configuration Guide - Basic Configuration 5 Configuring User Login

Issue 02 (2011-10-15) Huawei Proprietary and Confidential

Other manuals for Huawei AR2200 Series